- MENU
- Home
-
Categories
- Air conditioner (switchgear cabinet)
- Base/base element (switchgear cabinet)
- Case for component installation with modular spacing 19 inch
- Climate control door (enclosure/cabinet)
- Climate control side panel (enclosure/cabinet)
- Component for arrangement / baying system (switchgear cabinet)
- View all categories
- Accessories/spare parts for domestic switching devices
- Accessories/spare parts for socket outlets/plugs with protective contact
- Cable entry
- Combination of switch/push button with socket outlet
- Control element/cover plate for domestic switching devices
- Controller for light controlling system
- View all categories
- Accessories/spare parts for earthing and lightning
- Accessories/spare parts for surge protection data networks/MCR-technology
- Accessories/spare parts for surge protection power supply systems
- Air-termination equipment for lightning protection
- Base for air termination systems lightning protection
- Basic element for surge protection device
- View all categories
- AC-power supply
- Accessories/spare parts for command devices
- Accessories/spare parts for electronic motor control and protection device
- Accessories/spare parts for emergency stop pull cord switch
- Accessories/spare parts for frequency controller
- Accessories/spare parts for low-voltage switch technology
- View all categories
- Accessories/spare parts for underfloor installation ducting systems
- Bend for underfloor installation ducting systems
- Coupler for underfloor installation duct
- Cover for underfloor installation duct flush floor open
- Cover plate for installation units
- End piece for underfloor installation duct
- View all categories
- Request Quote
- How RFQ Works
- Contact Us
- FAQ
View larger
Images are for illustrative purposes only. Please refer to data sheet for details
Q 1,5/2A50/11-M20KU-ESA 1640728 PHOENIX CONTACT Panel feed-through
Q 1,5/2A50/11-M20KU-ESA
1640728
PHOENIX CONTACT
1 Pcs.
Panel feed-through
External passage, with 1.5 mm² conductor outlet and 0.5 m conductor, connection thread: M20, 2-pole
Panel feed-through with wire exit 1.5 mm2 and 0.5 m Litz wire: connecting thread: M20, 2-pos.
Connectors > Sensor-actuator connector chassis
QUICKON Installation System (QPD)
Product condition, packaging, certifications and applicable manufacturer warranty terms are confirmed with the quotation.
More info
▲Technical data
Product properties
| Product type | Panel feed-through |
| Number of positions | 2 |
| Position marking | 1, 2 |
| Number of connections | 2 |
| Number of connections per position | 1 |
| Shielded | no |
| Insulation characteristics | |
| Overvoltage category | III |
| Degree of pollution | 3 |
Connection data
| Connection technology | |
| Connection method On the device side | Single wires |
| Frequency of connections between conductors of the same cross section | 10 (if the conductor is connected more than once, seal and cap may need to be replaced.) |
| Conductor connection | |
| Conductor cross section flexibel | 0.75 mm² ... 1.5 mm² |
| Conductor cross section solid | 0.75 mm² ... 1 mm² |
| Connection cross section AWG | 18 ... 16 |
| Tightening torque Union nut | 2.5 Nm |
| Tightening torque Contact carrier | 3.75 Nm |
| Tightening torque Locking nut | 3.75 Nm |
| Wrench size Union nut | 22 mm |
| Wrench size Contact carrier | 22 mm |
| Pin assignment | |
| Contact Color (signal designation) Contact (optional) | 1 BN |
| 2 WH | |
Dimensions
| Dimensional drawing |  |
| Width | 22 mm |
| Height | 22 mm |
| Length | 43.7 mm |
Electrical properties
| Rated surge voltage (III/3) | 6 kV |
| Contact resistance | < 3 mΩ |
| rated voltage (II/2) | 630 V (with insulating sleeve) |
| rated voltage (III/2) | 320 V (with insulating sleeve) |
| Rated voltage (III/3) | 250 V (with insulating sleeve) |
| Nominal voltage UN | 250 V AC |
| 250 V DC | |
| Nominal current IN | 17.5 A |
Material specifications
| Color (Housing) | green (RAL 6021) |
| Material Housing | PA |
| Flammability rating according to UL 94 | V0 |
| Material wire insulation | PVC / PE |
| Contact material | Copper alloy |
| Contact surface material | Pre-nickel plated and tin-plated |
| Contact carrier material | PA 6.6 |
Cable/line
| Cable length | 0.5 m |
| Structure of individual litz in acc. with VDE 0295 / smallest wire diameter | VDE 0295 Cl.2-5, min. wire diameter 0.2 mm |
| Wire diameter including insulation | >= 3 mm |
| Position marking | 1, 2 |
| Cable cross section | 1.5 mm² |
Mounting
| Mounting type | Front mounting M20 |
| Assembly note | If the conductor is reconnected, it must be cut off above the last contact point. QUICKON components may only be operated when under no load. |
Environmental and real-life conditions
| Ambient conditions | |
| Degree of protection | IP65 |
| IP67 | |
| Impact strength | IK06 |
| Ambient temperature (operation) | -25 °C ... 80 °C (Specifications of the cable manufacturer must be observed.) |
| -25 °C ... 50 °C (when the conductor is connected. Specifications of the cable manufacturer must also be observed.) | |
| Temperature when conductor connected | -5 °C ... 50 °C |